Car Yearsto Avoid

GMC Sierra 1500 Brake Problems by Year

Every Sierra 1500 model year ranked by brake complaints filed with NHTSA, with what owners report, typical mileage and recalls.

From NHTSA owner complaints and recalls. Updated Nov 16, 2026.

Which Sierra 1500 years have brake problems?

The 2015, 2014 and 2000 Sierra 1500 have the most brake complaints filed with NHTSA, led by the 2015 with 229. Adjusted for time on the road, the 2010, 2013 and 2009 models have the fewest. Problems were most often reported at about 39,000–98,000 miles.

1,576 brake complaints 27 model years 65,000 miles typical

Brakes complaints by model year

Total complaints. Newer years have had less time on the road, so their totals will keep climbing.

What owners report

2015 Sierra 1500: Hard brake pedal and weak stopping at low speeds

Owners of the 2015 GMC Sierra 1500 report that the brake pedal becomes stiff and hard to press, and the truck slows poorly or not at all. This tends to happen at low speeds, such as parking lots, driveways, backing up, or stop signs. Several owners say dealers found a weak or failed brake vacuum pump, and some mention a recall that did not fully fix the problem.

2014 Sierra 1500: Hard brake pedal and weak low-speed stopping

Owners report that the brake pedal can suddenly turn stiff and very hard to press when the truck is moving slowly, such as while parking, backing up, or maneuvering with a trailer. Many point to the vacuum pump or brake booster as the likely cause, and some say the problem returned after repairs. Because it tends to come and go, and dealers often cannot reproduce it, owners frequently describe it as a safety concern.

2000 Sierra 1500: Corroded brake lines causing sudden pedal loss

Owners report that the steel brake lines on this truck rust through, often underneath near the ABS module, which lets fluid escape and the pedal sink toward the floor. Some describe it happening while driving at low speed, and others discover it when a leak or a soft pedal shows up in a parked truck. A smaller group reports the ABS engaging at low speed so the truck keeps rolling, and several say the rusted lines were replaced without fixing the wider problem.

Signs to watch for

  • Brake pedal feels stiff or hard to push
  • Truck keeps rolling despite pressing the pedal
  • Needs extreme force to stop at low speed
  • Longer stopping distance when parking or backing up
  • Brakes seem to fail after towing or in stop-and-go traffic
  • Brake pedal feels stiff or rock-hard at low speed

Sierra 1500 years with the fewest brake problems

Complaints per year on the road, counting only years with at least three years of owner reports. Fewer complaints doesn't guarantee a trouble-free car.

GMC Sierra 1500 brake recalls

Recalls covering the brakes on any Sierra 1500 year listed here, newest first. Check your VIN to see which apply to your car.

Brake fluid warning light may not appear

Crash risk

The brake control software may fail to turn on the warning light when brake fluid is low. Without that warning, a driver may keep driving with reduced braking performance, which raises the risk of a crash.

Fix: The dealer will update the electronic brake control module software, either over the air or in person, at no cost to you.

Recall 24V674000 · Sep 2024

Brake vacuum pump may lose power assist

Crash risk

The mechanical vacuum pump that helps the brakes can weaken over time, reducing brake power assist. Harder pedal effort and longer stopping distances raise the risk of a crash.

Fix: Dealers will reprogram the Electronic Brake Control Module at no cost to you.

Recall 20V603000 · Oct 2020

Brake caliper bolts may break under load

Crash risk

The bolts that hold the front and/or rear brake calipers in place may not have been heat treated, so they can break under load. If a bolt breaks, braking can weaken or the wheel can rub, which raises the risk of a crash.

Fix: A dealer will replace the brake caliper bolts at no cost to you.

Recall 20V116000 · Feb 2020

Software error can disable electronic brake assist

Crash risk

A software error in the brake control module can turn off electronic brake assist, so the car may not stop as quickly in an emergency. This loss of assistance raises the risk of a crash.

Fix: The dealer will reprogram the brake control module software at no charge.

Recall 20V055000 · Jan 2020

Software error can disable stability and ABS

Crash risk

A software error in the brake control module can turn off the electronic stability control and antilock brakes without any warning light. Drivers who don't know these systems are off face a higher risk of crashing.

Fix: The dealer will reprogram the brake control module free of charge.

Recall 19V889000 · Dec 2019

Wheel sensor failure can cause sudden pulling

Crash risk

If a wheel-speed sensor fails while the vehicle is going between 41 and 60 mph in four-wheel or automatic mode, the brake control software can wrongly apply the brake on one wheel. The vehicle may then pull sharply to one side without warning, which raises the risk of a crash.

Fix: The dealer will reprogram the brake control module (EBCM) at no cost to you.

Recall 19V761000 · Oct 2019

Brake assist can weaken over time

Crash risk

The vacuum pump may gradually lose its ability to build enough vacuum for the brake booster. Less brake assist means you must press harder and the car takes longer to stop, which raises the risk of a crash.

Fix: The dealer will reprogram the Electronic Brake Control Module free of charge, and GM will notify owners by mail.

Recall 19V645000 · Sep 2019

Replacement hub can weaken ABS sensor signal

Crash risk

Certain aftermarket hub assemblies for 2001-2006 GM 1500 and 2500 4WD trucks can have the ABS sensor cord pinched by the dust shield, which weakens the sensor signal. This can cause unwanted ABS activation at low speeds and can lengthen stopping distance, which could lead to a crash.

Fix: Federal-Mogul will notify you and will either credit your account or replace the hub assembly.

Recall 06E050000 · Jun 2006

Kinked brake booster vacuum hose

The hose that supplies vacuum to the brake booster was built with a kink, so these trucks and SUVs do not meet the federal hydraulic brake standard (FMVSS 105). A kinked hose can restrict the vacuum the brake booster relies on.

Fix: The dealer will re-route the brake booster vacuum supply hose to remove the kink.

Recall 00V222000 · Aug 2000
Check your VIN for open recalls

Get an email when your car gets a new recall

We check NHTSA every day. If a new recall or safety investigation covers your car, you'll hear about it the same week.

Your car

One email per new recall for the car you pick. No spam, unsubscribe anytime.

Other GMC Sierra 1500 problems

Common questions

What years does the GMC Sierra 1500 have brake problems?

The 2015, 2014 and 2000 Sierra 1500 have the most brake complaints filed with NHTSA, led by the 2015 with 229. Adjusted for time on the road, the 2010, 2013 and 2009 models have the fewest. Problems were most often reported at about 39,000–98,000 miles.

What is the worst year for GMC Sierra 1500 brake problems?

The 2015 Sierra 1500, with 229 brake complaints, followed by the 2014 (144).

Which GMC Sierra 1500 years have the fewest brake problems?

The 2010, 2013 and 2009 models, counting complaints per year on the road and only years with at least three years of owner reports.

What are common GMC Sierra 1500 brake problems?

Owners of the 2015 GMC Sierra 1500 report that the brake pedal becomes stiff and hard to press, and the truck slows poorly or not at all. This tends to happen at low speeds, such as parking lots, driveways, backing up, or stop signs. Several owners say dealers found a weak or failed brake vacuum pump, and some mention a recall that did not fully fix the problem.

At what mileage do GMC Sierra 1500 brake problems start?

Across all years, most complaints that gave a mileage fell between about 39,000–98,000 miles, with a middle value near 65,000 miles.

Is there a recall for GMC Sierra 1500 brake problems?

NHTSA lists 9 recalls covering the brakes on these Sierra 1500 years. Check your VIN at nhtsa.gov/recalls to see if the work was done on your car.

Source: NHTSA complaints and recalls databases. Complaints are unverified owner reports, summarized in our own words. Counts include each complaint once per model year, for years with at least 25 complaints.

Terms & Conditions

Car Years to Avoid summarizes public NHTSA owner complaint and recall data for general information only. Complaints are unverified owner reports, so treat them as a guide, not a verdict on any specific vehicle.

Nothing here is mechanical, legal or buying advice. Always check a VIN at nhtsa.gov/recalls and get a pre-purchase inspection. We may earn from ads and partner links. Not affiliated with NHTSA or any automaker.

Privacy

If you sign up for recall alerts, we store your email and the car you picked, and use them only to send those alerts. We never sell your email, and you can unsubscribe anytime from any alert.

Like most sites, we use cookies and analytics tools (Google Analytics and Microsoft Clarity) to understand how people use the site and keep it free.