2020 Ford Explorer Jerking When Accelerating
From NHTSA owner complaints and recalls. Updated Nov 16, 2026.
Why does my 2020 Ford Explorer jerk when accelerating?
130 owners of the 2020 Ford Explorer describe jerking when accelerating in complaints to NHTSA, 10% of all complaints for this year. Most of those complaints point to the transmission and engine. It was most often reported at about 6,000–77,000 miles. 10 recalls cover those systems on this year.
130 complaints 10% of all 2020 complaints 19,000 miles typical
What owners describe
Owners describe jerking, lurching, or hard shifts that most often happen when the transmission changes gears, especially on downshifts while slowing down, and sometimes when pulling away from a stop or shifting out of Park. Some say the car hesitates, stalls, or rolls before the jolt, which made them worry about safety in traffic. Several report that the dealer confirmed a transmission problem, but some were told the parts were on backorder or that the issue was not diagnosed at all.
What owners and dealers blamed
- transmission failure or damage
- oil drain plug not tight enough, per dealer
- power train recall campaign
Repairs owners mention
- transmission replaced
- valve body replaced
- shift kit installed
Which systems are involved
The system each of these complaints names. One complaint can name several.
Mileage when it started
Each dot is a complaint that gave a mileage (58 of 130). The amber line is the middle value.
When it was reported
Complaints by the year the problem happened.
Jerking When Accelerating by Explorer year
Complaints describing this symptom, for model years with enough complaints to compare.
Related recalls
Park pawl can engage while driving
Crash risk
The transmission's park pawl, the part that locks the drive wheels in Park, can engage while the vehicle is moving. This can damage the park system and let the vehicle roll away, raising the risk of a crash.
Fix: Dealers will update the powertrain control module software and inspect and replace any damaged transmission parts, free of charge.
Recall 26V402000 · Jun 2026Rear axle bolt can break, driveshaft disconnects
Crash risk
The bolt that holds the rear axle in place can break, allowing the driveshaft to disconnect. This can let the vehicle roll away even when it is in park without the parking brake applied, or cause a loss of drive power, both of which raise the risk of a crash.
Fix: Your dealer will update the powertrain control module software at no cost to you.
Recall 25V166000 · Mar 2025Engine failure can cause under-hood fire
Fire risk
If the engine fails, oil and fuel vapor can leak into the engine bay and ignite on hot engine or exhaust parts, possibly starting a fire. Such a fire raises the risk of injury, so pull over and shut off the engine as soon as you hear unusual engine noise, lose power unexpectedly, or see smoke from under the hood.
Fix: The dealer will update the Powertrain Control Module (engine computer) software to address the problem.
Recall 24V598000 · Aug 2024Rear axle bolt can break, driveshaft detaches
Crash risk
The bolt that holds the rear axle can break, which can let the driveshaft disconnect. That can cause loss of drive power or a rollaway if the parking brake is not set, raising the risk of a crash.
Fix: The dealer will replace the subframe bushing and rear axle bolt, and will also inspect the rear axle cover near the bolt hole and replace it if it is damaged.
Recall 23V675000 · Oct 2023Parking brake may not engage automatically
Crash risk
A previous software update left the automatic electronic parking brake inactive when the vehicle is shifted into Park. The rear axle mounting bolt can also break, letting the driveshaft disconnect, which can cause rollaway or loss of drive power and raise the risk of a crash.
Fix: The dealer will update the powertrain control module software at no cost to you.
Recall 23V199000 · Mar 2023Unexpected computer reset can damage park system
Crash risk
The engine computer can unintentionally reset while the car is moving, which can damage the parking system. A damaged park system may fail to shift into Park, so the vehicle can roll away and raise the risk of injury or a crash.
Fix: The dealer will inspect the park system for damage and repair it if needed, free of charge.
Recall 23V069000 · Feb 2023Rear axle bolt can break, dropping driveshaft
Crash risk
A rear axle mounting bolt can break, allowing the driveshaft to disconnect. If the vehicle is put in Park without the parking brake applied, it can roll away and increase the risk of a crash.
Fix: The dealer will replace the bushing and axle cover or update the electronic parking brake software, depending on your model, and the repair is free of charge.
Recall 22V255000 · Apr 2022Loose motor mount can cause power loss
Crash risk
The bolts that hold the right-hand motor mount may have been tightened incorrectly and can loosen over time. If the mount loosens, engine vibration can pull the axle apart from the engine, causing a sudden loss of power and raising the risk of a crash.
Fix: Ford will notify you, and your dealer will remove and replace the right-hand motor mount fasteners free of charge.
Recall 20V788000 · Dec 2020Drive shaft may fracture, causing rollaway
Crash risk
The drive shaft can crack along a weld, which may cause the vehicle to roll away while in Park or lose drive power. The shaft can also bend loose and touch the fuel tank, raising the risk of fuel leaks and fire.
Fix: Dealers will inspect the drive shaft and replace it if needed, free of charge.
Recall 20V693000 · Nov 2020Gear lever can move, letting car roll away
Crash risk
The manual park release cover may be missing, so the release lever can be bumped and the car can roll away unexpectedly. The dashboard may also be in a factory mode that turns off warning alerts and hides which gear is selected, raising the chance of a crash.
Fix: The dealer will inspect the vehicle, install a manual park release cover if needed, and check that the instrument cluster is not in factory mode, all free of charge.
Recall 19V575000 · Aug 2019Get an email when your car gets a new recall
We check NHTSA every day. If a new recall or safety investigation covers your car, you'll hear about it the same week.
One email per new recall for the car you pick. No spam, unsubscribe anytime.
More 2020 Ford Explorer problems
Common questions
Why does my 2020 Ford Explorer jerk when accelerating?
130 owners of the 2020 Ford Explorer describe jerking when accelerating in complaints to NHTSA, 10% of all complaints for this year. Most of those complaints point to the transmission and engine. It was most often reported at about 6,000–77,000 miles. 10 recalls cover those systems on this year.
What causes jerking when accelerating in the 2020 Ford Explorer?
Owners and dealers most often blamed transmission failure or damage, oil drain plug not tight enough, per dealer and power train recall campaign. These are owner reports, so have a mechanic confirm the cause.
How do owners fix jerking when accelerating in the 2020 Ford Explorer?
Repairs owners describe include transmission replaced, valve body replaced and shift kit installed. Ask a dealer whether a recall or service bulletin covers it first, since that work can be free.
At what mileage does the 2020 Ford Explorer start jerking when accelerating?
Most complaints that gave a mileage fell between about 6,000–77,000 miles, with a middle value near 19,000 miles.
Is there a recall for jerking when accelerating on the 2020 Ford Explorer?
10 recalls cover the transmission and engine on this year: 26V402000, 25V166000, 24V598000, 23V675000. Check your VIN at nhtsa.gov/recalls to see if the work was done.
Source: NHTSA complaints and recalls databases. Complaints are unverified owner reports, summarized in our own words. A complaint counts here when the owner's own description mentions this symptom.